Xerox WorkCentre C226 User Manual page 50

General Information
1-24
1. Open the Bypass Tray.
Be sure to pull the tray extension all the way out. If the tray extension is not pulled
all the way out, the size of the paper loaded in the Bypass Tray may not display
correctly.
2. Set the Bypass Tray guides to the width of the copy paper.
3. Insert the copy paper all the way into the Bypass Tray. (Do not force the paper in.)
loaded in the Bypass Tray.
When loading paper that will extend past the end of the
tray, pull out the tray extension to support the paper and
to allow the paper sensors to properly sense the paper
size.
To support papers that extend past the tray extension,
pull out the wire extension.
Place the copy paper face up. If the Bypass Tray guides
are set wider than the copy paper, the inside of the
machine may become soiled, resulting in smudges on
succeeding copies.
Special purpose papers other than Xerox-recommended
transparency film must be fed individually. Multiple
sheets of Xerox-recommended transparency film can be
Xerox WorkCentre C226 User Guide