Faxing A Divided Original (Dual - Xerox WorkCentre C226 User Manual

Direction of transmission
Outside scanned data
Faxing a Divided Original (Dual Page Scan)
Your machine
Book or sheet original
When page division is set,
Xerox WorkCentre C226 User Guide
Position of sender's information
The key operator program can be used to select whether the sender's information is
added outside the original data or inside the data. (See the "Fax Unit" section of the
WorkCentre C226 System Administration Guide). The initial factory setting is outside
the data.
None of the transmitted
image is cut off; however,
the transmitted data is
longer than the scanned
data, and thus when both
the sender and the
receiver use the same size
of paper, the printed fax
may either be reduced or
split up and printed on two
pages.
When an open book is scanned and faxed, you can use this function to divide the two
open pages of the book into two separate fax pages.
This function can only be used when the original is scanned using the document glass.
Transmission to
other machine
the original is divided
into two pages when
scanned into memory
Faxing a Divided Original (Dual Page Scan)
Direction of transmission
Inside scanned data
The other machine
[Example]
Scanned original size
A3 (11"x17") Two A4 (8-1/2"x11") pages
The top edge of the
scanned data will be cut off
by the sender's informa-
tion; however, when both
the sender and the
receiver use the same size
of paper, the printed fax
will neither be reduced nor
split up and printed on two
pages.
Printed out as
two separate pages
Transmitted document
5-43