NOTE:
Loading paper in the Bypass Tray
NOTES:
Xerox WorkCentre C226 User Guide
4. Load paper into the tray.
5. Gently push tray 1 into the machine.
6. Set the paper type of the paper that was loaded in the 1st tray.
If you loaded a different type of paper from the previous paper, be sure to set the
new paper type as explained in "Setting the paper type (except the Bypass Tray)"
on page 1-33.
Changing paper size in Paper Tray 1 is now complete.
If the size slide position (step 2 of page 1-22) is not set correctly after changing the
paper size, or if the paper type (page 1-33) is not set correctly, incorrect paper
selection or paper misfeeding may occur.
The Bypass Tray can be used to feed the same paper specified for Paper Tray 1 or for
special papers. For paper types that can be used in the Bypass Tray, see the specifi-
cations for the Bypass Tray in the paper tray specifications (page 1-30).
Up to 250 sheets of Xerox standard paper or up to 100 postcards can be set in the
Bypass Tray.
•
After loading the paper in the Bypass Tray, be sure to set the paper type and size
(step 4) if these were changed.
•
Do not use inkjet paper. This may cause misfeeds in the fusing unit.
Push the tray firmly all the way into the machine.
Loading Paper
1-23