Description Of Setting Programs; Printer Settings; Default Settings; A4/Letter Size Auto Change - Xerox WorkCentre C226 User Manual

Description of Setting Programs

Printer settings

NOTE:
Xerox WorkCentre C226 User Guide
The key operator programs related to the printer function are explained here.

Default settings

These programs are used to adjust the settings of various printer functions.
Prohibit notice page printing
This program is used to disable notice page printing.
Turn on this program when you do not want the machine to print the notice page
explained in "Notice Page Printing" on page 3-65.
Prohibit test page printing
This program is used to disable test page printing.
When the program is turned on, the PRINTER TEST PAGE in the user settings cannot
be printed. (See page 1-41)

A4/letter size auto change

If this program is set, and printing onto 8-1/2" x 11" size paper is selected but not avail-
able, the printer will automatically substitute A4 size paper in place of 8-1/2" x 11"
paper if A4 paper is available.
* 8-1/2" x 11" paper cannot be automatically selected in place of A4.
When 8-1/2" x 11" size is specified for a document attached to an E-mail that has been
transmitted from a foreign country and A4 size paper is not installed in the printer,
printing cannot be done without operator intervention. If this program is set, printing
will be executed without intervention if a paper tray is loaded with A4 paper.

Delete the print hold data

Use this program to manually delete all stored data from the hard disk.
When you touch this key, a message will appear to confirm that you want to delete the
data. Check the message and then proceed with the deletion. If you are using the job
retention function (page 3-48), exercise caution when using this program.

Output method when memory is full

When the internal memory becomes full with printer data, further printing is not possi-
ble, thus the print data stored to that point is printed. This program is used to set the
condition for printing. The factory default setting is "1 SET".
Description of Setting Programs
3-55