Dadf; Acceptable Originals - Xerox WorkCentre C226 User Manual

Copy quantity
display
Copy Ratio
display
Exposure tab
Paper Select
display
Original tab
2-Sided Copy
display
Special Modes
tab
Output display
NOTE:

DADF

Acceptable originals

Xerox WorkCentre C226 User Guide
Displays the selected number of copies before the [START] key is pressed or the num-
ber of remaining copies after the [START] key is pressed. A single copy can be made
when "0" displayed.
Use to select the copy ratio (page 2-30).
Touch to adjust the copy exposure (page 2-25).
Use to select the paper size (page 2-14, 2-22). The display shows the location of the
paper trays, the size of the paper in the trays and the approximate amount of paper
loaded in each tray. The approximate amount of paper in a tray is indicated by
Touch this tab to manually enter the original size (page 2-8).
Use to select the duplex copy mode setting (pages 2-19, 2-24).
Touch to display the Special Modes screen (page 2-37).
Use to select sort, group, and staple sort, (pages 2-14, 2-23).
For a description of the Operation Panel, see page 1-14.
The DADF can be used to automatically feed originals for continuous copying. Both
sides of two-sided sheet originals can be scanned without having to manually turn the
originals over. This feature is convenient for making copies of a large number of origi-
nals.
When the DADF is used, up to 40 originals of the same size can be set in the feeder
(maximum stack thickness of 4 mm (11/64"), or 30 originals of weight 90 g/m2 (24
lbs.)).
DADF
.
2-3