Xerox WorkCentre C226 User Manual page 171

Xerox WorkCentre C226 User Guide
1. Touch the [A3 FULL-BLEED] key on the IMAGE EDIT menu screen.
Single Colour
A3
Full-Bleed Enla
2. Touch the [OK] key on the IMAGE EDIT menu screen.
Return to the SPECIAL MODES screen.
3. Touch the [OK] key on the SPECIAL MODES screen.
Return to the main screen of copy mode.
4. Load A3W (12" x 18") copy paper into the Bypass Tray.
then select the paper type in the Bypass Tray.
Ready To Copy.
1. A4 Plain
Recycled
2. B4
3. A3 Colour
4. A4R Plain
Touch the [PLAIN] key or the [HEAVY PAPER] key.
If you touched the [HEAVY PAPER] key, touch the [HEAVY PAPER1] key or the
[HEAVY PAPER2] key as appropriate for the weight of the paper you loaded (see
step 3 on page 1-36).
About the steps that follow
See page 2-21.
Extend the copy receptacle and then begin copying.
To cancel the A3 (11 x 17) FULL-BLEED function, touch the [A3 FULL-BLEED] key
again on the IMAGE EDIT menu screen (step 1).
The [A3 FULL-BLEED] key will be highlighted to indicate
that the function is turned on, and the full-bleed icon
( ) will appear in the upper left of the screen.
Mult
Adjust the Bypass Guide to A3W width before loading
the paper. Remove any paper remaining in the tray.
Pull out the tray extension and wire extension (see
page 1-23).
5.Touch the [More...] key in the Paper Select display and
0
Interrupt
Auto
A3W
Original
Plain
Auto
Exposure
Heavy Paper
Transparency
Paper Select
100
%
Envelope
Copy Ratio
Image Edit Menu
2-67