Xerox WorkCentre C226 User Manual page 84

General Information
Problem
Is paper other than Xerox-recommended
paper being used?
Paper curled or damp?
Is the paper curled and does it frequently
misfeed in the Duplex Module/2-Tray Unit
or Saddle Stitch Finisher?
Paper misfeeds
frequently.
Multiple sheets of paper fed simulta-
neously?
Is paper other than Xerox-recommended
paper being used?
Is paper size or weight out of the allow-
able range?
Do wrinkles appear when printing enve-
Printed paper is
lopes?
wrinkled or the
image rubs off
easily.
Is the pressure adjustment lever of the
fusing unit out of position?
Paper damp?
The contrast on
the touch panel is Is LCD contrast properly adjusted?
too high or too low.
1-58
Check Solution or cause
Use Xerox-recommended paper.
Do not use curled or crimped paper. If
you do not use paper for a long time,
store paper in the wrapper in a dry loca-
tion.
Paper may be curled when output
depending on the paper type and quality.
In some cases turning the paper over in
the tray will reduce misfeeding due to
curling.
Remove the paper from the paper tray or
the Bypass Tray, fan the paper as shown
in the illustration, and then load it again.
Use Xerox-recommended paper.
Use paper in the allowable range.
Moving the pressure adjusting levers of
the fusing unit from the normal position to
a weaker pressure position may help alle-
viate this problem. (page 1-27)
Return the pressure adjusting levers of
the fusing unit to the normal position.
(page 1-28)
Be sure to store paper in the wrapper in a
dry location and do not store paper in a
location that is humid at a high tempera-
ture or an extremely low temperature.
Adjust the contrast using "DISPLAY
CONTRAST" of custom settings.
(page 1-37)
Xerox WorkCentre C226 User Guide