Misfeed Removal - Xerox WorkCentre C226 User Manual

General Information

Misfeed Removal

NOTE:
NOTES:
1-46
When a misfeed has occurred during printing, the message "MISFEED HAS
OCCURRED." will appear in the touch panel display of the operation panel and print-
ing output will stop. The approximate locations of possible misfeeds are indicated by
" " in the illustration below. The page numbers for detailed information for misfeed
removal for each are also shown.
Received faxes are all temporarily stored in memory. If a paper misfeed occurs,
received faxes cannot be printed. When the misfeed is removed, the received faxes
will print out automatically.
• Be careful not to tear the misfed paper during removal.
• If paper is accidentally torn during removal, be sure to remove all pieces.
• Take care not to damage or leave fingerprints on the transfer belt when removing
the misfed paper.
CAUTION
The fusing unit is hot. Take care in removing paper.
Upper fusing unit
Misfeed in the fusing area,
and exit area (page 1-50)
Misfeed in the Duplex Bypass
/Inverter Unit (page 1-53)
Misfeed in the Saddle Stitch
Finisher (page 1-67)
Misfeed in the DADF
(see page 2-79 in the "Copier
Operation" section)
Misfeed in the transport area
(page 1-49)
Fusing unit paper guide
Xerox WorkCentre C226 User Guide
Misfeed in the Bypass Tray
(page 1-48)
Misfeed in the 1-Tray Unit
(page 1-47)
Misfeed in the Duplex
Module/2-Tray Unit (page 1-
55)
Misfeed in the stand/1-Tray
Unit or the 3-Tray Unit
(page 1-53
Misfeed in the High Capacity
Feeder (page 1-75)
Transfer belt