Cable Seal Assembly; Cable Seal Identification - Omron eCobra 600 User Manual

9.3 Cable Seal Assembly

This section describes the cable seal assembly that is provided with the IP65 option, and
provides instructions for properly installing the seal.

Cable Seal Identification

You must mount the cable seal assembly (part number 04813-000) on the back of the robot dur-
ing the robot installation process. The cable seal assembly ships separately from the robot. Use
the figure below to identify the cable seal assembly parts. Figure 9-4.
Item
Cable Seal Housing
A
Part number 04814-000
Cable Seal Flange (upper)
B
Part number 04816-000
Splash Guard
C
Part number 04817-000
Cable Seal Flange (lower)
D
Part number 04815-000
Installation Procedure
Use the following procedure to install the cable seal assembly.
156
Figure 9-4. Cable Seal Parts Assembly
NOTE: Shown with Cable Seal (P/N 04818-000) in place.
eCobra 600 and 800 Robots with EtherCAT
Description
24402-000 Rev B