Table of Contents
Advertisement
Connection
the robot's Joint 1.
2nd group of IO Blox con-
nect to FORCE/EXPIO
branch of the XBELTIO
cable.
Optional XIO
Termination Block,
connects to iCS-ECAT
robot interface panel
Digital I/O Signal Configuration
This section provides information about digital I/O signal configuration..
NOTE: The eCobra Standard can only support a maximum of 4 daisy-chained
IO Blox devices.
IO Blox Connections
When installing more than one IO Blox unit in a system, you must connect the units with the
supplied cable(s) and set the address select switch correctly for each additional unit.
NOTE: Each IO Blox unit (up to 4 for Standard, 8 for Pro) must have a unique
address. IO Blox units with duplicate addresses will conflict. Refer to the IO Blox
User's Guide (04638-000) for more information.
Figure 4-7. Connecting IO Blox to the system (maximum of 4 for Standard, 8 for Pro)
68
I/O Capacity
devices for the eCobra Pro
12 inputs
8 outputs
eCobra 600 and 800 Robots with EtherCAT
Additional Information
Refer to Digital I/O Signal
Configuration on page 68
24402-000 Rev B
Advertisement
Table of Contents
