YASKAWA VIPA System SLIO Manual page 83

VIPA System SLIO
Parameter
HB300 | CPU | 013-CCF0R00 | en | 19-30
n Miscellaneous
– Direct DX transition
– PN MultipleWrite
– Free Module Mapping
– Reduced PDU size
Ä 90
n Access settings
CPU
– Activation of interfaces and ports
– Activation of protocols
The following parameters may be accessed by means of the properties dialog of the
CPU.
Diagnostics interrupt (default: deactivated)
n Diagnostics interrupt 5L+ (DC 24V DI power section supply)
n Diagnostics interrupt 2L+ (DC 24V DO power section supply)
n Diagnostics interrupt 3L+ (DC 24V System SLIO bus power section supply)
Diagnostics interrupt DO short circuit/overload
n
n Diagnostics interrupt sensor short circuit/overload
MPI
n Function X3
Functionality of the MPI(PtP) interface X3
– MPI/DP (default): In this operating mode parameters are active, which you set on
sub module 'MPI/DP' of the Siemens CPU 314C-2 PN/DP.
Deployment PROFIBUS communication' page 254
– PTP: With this operating mode the RS485 interface acts as an interface for serial
point-to-point communication. Here data may be exchanged between two stations
by means of protocols.
Retentive data
n Additional retentive memory
– Here enter the number of retentive memory bytes. With 0 the value
'Retentive memory è Number of memory bytes starting with MB0' is set, which is
pre-set at the parameters of the Siemens CPU.
– Range of values: 0 (default) ... 8192
n Additional retentive timer
– Enter the number of S7 timers. With 0 the value 'Retentive memory
è Number S7 timers starting with T0' is set, which is pre-set at the parameters of
the Siemens CPU.
– Range of values: 0 (default) ... 512
n Additional retentive counter
– Enter the number of S7 counter. With 0 the value 'Retentive memory
è Number S7 counters starting with C0' is set, which is pre-set at the parameters
of the Siemens CPU.
– Range of values: 0 (default) ... 512
OB
Priority OB 57
n
– Here you can set the priority for the OB 57.
– Range of values: 2 (default) ... 24
n OB 80 for cyclic interrupt error
– Here you can set for which cyclic interrupt OB 80 (time error) should be called.
– Range of values: Deactivated (default), selection of the corresponding OB
Setting VIPA specific CPU parameters
Ä 85
Ä Chap. 6 'Deployment PtP communication' page 170
Deployment CPU 013-CCF0R00
Ä Chap. 11 'Option:
83