YASKAWA VIPA System SLIO Manual page 306

Configuration with TIA Portal
TIA Portal - Deployment PG/OP communication - PROFINET > Deployment as PROFINET IO controller
Assign IP address param-
eters
13.6.1.3 Configuration PROFINET IO controller
13.6.1.3.1 Proceeding
Precondition
Proceeding
306
This function is supported only if the PROFINET IO controller is not yet configured. You
get valid IP address parameters from your system administrator. The assignment of the
IP address data happens online in the Siemens TIA Portal with the following proceeding:
1. Start the Siemens TIA Portal.
2. Switch to the 'Project view' .
3. Click in the 'Project tree' at 'Online access' and choose here by a doubleclick your
network card, which is connected to the PROFINET interface.
4. To get the stations and their MAC address, use the 'Accessible device' . This can
be found at the front of the CPU labelled as "MAC ETH: ...".
5. Choose from the list the module with the known MAC address and open with
"Online & Diagnostics" the diagnostics dialog in the Project area.
6. Navigate to Functions > Assign IP address. Type in the IP configuration like IP
address, subnet mask and gateway.
7. Confirm with [Assign IP configuration].
ð Directly after the assignment the PROFINET IO controller is online reachable
using the set IP address data. The hardware configuration allows you to transfer
the IP address data to your project.
uration - CPU' page 296
To parametrize the PROFINET IO controller of the CPU, the following conditions must be
fulfilled:
The PROFINET IO controller is online reachable, this means an initialization was
n
established.
n The hardware configuration described before was established and the PROFINET IO
controller is networked.
1. For parametrization click in the Project area at the CPU part.
2. Click on 'PROFINET interface' in the Device overview.
ð The parameters of the PROFINET interface are listed in the properties dialog.
VIPA System SLIO
Ä Chap. 13.3 'TIA Portal - Hardware config-
HB300 | CPU | 013-CCF0R00 | en | 19-30