Table of Contents
Advertisement
VIPA System SLIO
PG/OP1: X1
PG/OP2: X2
Disable communication on
the Mirror Port
Save
4.11.1.2
Web page with selected module
Structure
Module
Tab: 'Info'
Tab: 'Data'
Tab: 'Parameter'
HB300 | CPU | 013-CCF0R00 | en | 19-30
When enabled the frames of PG/OP2: X2 are mirrored to PG/OP1: X1.
When enabled the frames of PG/OP1: X1 are mirrored to PG/OP2: X2.
When enabled additional communication via the mirrored interface (Mirror Port) is pre-
vented.
With Save, the setting are taken and activated. The next power-cycle will automatically
disable Port Mirroring.
The web page is built dynamically and depends on the number of modules, which are
connected to the CPU. The web page only shows information. The shown values cannot
be changed
Please consider the System SLIO power and clamp modules do not have
any module ID. These may not be recognized by the CPU and so are not
listed and considered during slot allocation.
Here product name, order number, serial number, firmware version and hardware state
number of the according module are listed.
Here the address and the state of the inputs respectively outputs are listed. Please note
with the outputs that here exclusively the states of outputs can be shown, which are
within the OB 1 process image.
With parametrizable modules e.g. analog modules the parameter setting is shown here.
These come from the hardware configuration.
Deployment CPU 013-CCF0R00
Accessing the web server > Device web page CPU
101
Advertisement
Table of Contents
