YASKAWA VIPA System SLIO Manual page 376

Hide thumbs Also See for VIPA System SLIO:
Table of Contents

Advertisement

VIPA System SLIO
System specific event IDs
Event ID
Description
21: MGT: Take-over of component data basis causes the hot restart of the component
23: Stopping the sub-system after having loaded the already existing consistency-secured SDBs xxxx by
the rack component
25: The SIMATIC procedure has been selected for the time synchronisation of the component.
26: Component actively established a connection
28: The SDB xxxx loaded by the rack component is the consistency securing object (SDB type 0x3118)
29: The component actively disconnected the system connection to the CPU
31: Inconsistency of the component data base by loading SDB xxxx by the rack component (SDB type
0x3100)
32: Periphery enabled by S7-CPU
33: Periphery disabled by S7-CPU
34: Component STOP due to switch actuation
35: Component STOP due to invalid configuration
36: Component STOP due to PG command
38: SDB xxxx is not registered in the still valid consistency securing object, or it has an incorrect time
stamp (SDB type 0x3107), the error is being corrected
40: Memory reset executed
44: Consistency of the data base achieved after loading the SDBs xxxx by the rack component (SDB type
xxxx)
45: Remanent part of the component data base is deleted by the rack component after being loaded
70: Restore factory defaults (same as memory reset of CPU!)
83: Network interface: automatic configuration, TP/ITP with 10 Mbit/s semi-duplex
96: The MAC address was retrieved from the system SDB. This is the configured address.
97: The MAC address was retrieved from the boot EPROM. This is the factory-provided address.
100: Restart of the component
101: Component STOP due to deletion of system SDBs
104: PG command start was denied due to missing or inconsistent configuration
105: Component STOP due to double IP address
107: Start-up request by switch actuation was denied due to missing or inconsistent configuration
PK: NCM_SERVICE
2: Management
3: Object management system
6: Time synchronisation
10: IP_CONFIG
38: SEND/RECEIVE
376
HB300 | CPU | 013-CCF0R00 | en | 19-30

Advertisement

Table of Contents
loading

Table of Contents