Table of Contents
Advertisement
Deployment CPU 013-CCF0R00
Setting VIPA specific CPU parameters
Address
4.9 Setting VIPA specific CPU parameters
Overview
82
n
Properties
–
With this button the properties of the interface may be pre-set.
n
Comment
–
You can enter the purpose of the interface.
Diagnostics
n
–
A diagnostics address for the interface is to be pre-set here. In the case of an
error the CPU is informed via this address.
n
Operating mode
–
With the interface type 'PROFIBUS' here you can pre-set the 'Operating mode'
DP Slave.
n
Configuration, Clock
–
These parameters are not supported.
Except of the VIPA specific CPU parameters the CPU parametrization takes place in the
parameter dialog of the CPU 314C-2 PN/DP (314-6EH04-0AB0 V3.3) from Siemens.
After the hardware configuration of the CPU you can set the parameters of the CPU in
the virtual IO device 'VIPA SLIO CPU' . Via double-click at the 'VIPA SLIO System' 013-
CCF0R00 CPU the properties dialog is opened.
Here the following parameters may be accessed:
n
Diagnostic
–
Diagnostic interrupt in case of short circuit or overload of the power supplies
n
MPI - function X3
–
Functionality of X3
n
Retentive data
–
Additional retentive memory, timer respectively counter
OB
n
–
Priority OB 57
–
Call OB 80 on cyclic interrupt
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 19-30
Advertisement
Table of Contents
