Table of Contents
Advertisement
Deployment PG/OP communication - productive
Configure Siemens S7 connections
Requirements
Work environment of
NetPro
222
n
Both participant have equal rights, i.e. every participant may initialize the send res.
receive process event controlled.
n
Except of the UDP connection, at a communication connection the address of the
communication partner is set via the project engineering. Here the connection is
active established by one station.
Siemens SIMATIC Manager V 5.5 SP2 or higher and SIMATIC NET are installed.
n
n
With the hardware configuration the according CP was assigned with IP address data
by its properties.
Every station outside of the recent project must be configured as replace-
ment objects like e.g. Siemens "SIMATIC S5" or "other station" or with the
object "In unknown project". When creating a connection you may also
choose the partner type "unspecified" and set the required remote param-
eter directly in the connection dialog.
For the project engineering of connections, a thorough knowledge with NetPro from Sie-
mens is required! The following passage only describes the basic usage of NetPro. More
detailed information about NetPro is to be found in the according online manual res. doc-
umentation. Start NetPro by clicking on a "net" in the Siemens SIMATIC Manager or on
"connections" within the CPU.
The environment of NetPro has the following structure:
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 19-30
Advertisement
Table of Contents
