Table of Contents
Advertisement
VIPA System SLIO
Plug connector
2.6.2 Demounting periphery modules
Proceeding
Exchange of an electronic
module
Exchange of a periphery
module
HB300 | CPU | 013-CCF0R00 | en | 19-30
5.
To mount the CPU put it to the periphery module and push it, guided by the stripes,
to the mounting rail.
6.
Turn all the locking lever downward, again.
7.
Plug again the electronic module, which you have removed before. For installation
plug the electronic module guided by the strips at the lower side until this engages
to the terminal module.
Put the connector on the bottom edge and push it, as shown in the figure, with a
rotation upwards into the release lever until it engages.
ð Now you can bring your system back into operation.
1.
Power-off your system.
2.
For the exchange of a electronic module, the electronic module may be pulled for-
ward after pressing the unlocking lever at the lower side of the module.
3.
For installation plug the new electronic module guided by the strips at the lower side
until this engages to the terminal module.
ð Now you can bring your system back into operation.
1.
Power-off your system.
2.
Remove if exists the wiring of the module.
Basics and mounting
Demounting > Demounting periphery modules
33
Advertisement
Table of Contents
