YASKAWA VIPA System SLIO Manual page 51

VIPA System SLIO
LEDs CPU
SF RN
red green
Boot-up after PowerON - as soon as the CPU is supplied with 5V, the
Operation
X
X
2Hz
X
X
X X
X X
X X
Overall reset
X
X
X
Reset to factory setting
Firmware update
2Hz
2Hz
10Hz
not relevant: X
HB300 | CPU | 013-CCF0R00 | en | 19-30
ST FC
yellow yellow
X
X
X
X
10Hz
X
X X
X
X X
X
10Hz
X
1Hz
X
2Hz
X
10Hz
2Hz
2Hz
10Hz 10Hz
SD Description
yellow
green PW-LED (Power) is on.
Firmware is loaded, here the SF-LED flickers.
Initialization: Phase 1
Initialization: Phase 2
Initialization: Phase 3
Initialization: Phase 4
X CPU is in STOP state.
X CPU is in start-up state.
During the start-up (OB 100) the RUN LED blinks for at least 3s.
X Activation of a new hardware configuration
X CPU is in state RUN without error.
X There is a system fault. More information can be found in the
diagnostics buffer of the CPU.
page 117
X Variables are forced.
Accessing the memory card.
X Configuration is loaded.
X Overall reset is requested.
X Overall reset is executed.
X Overall reset with none hardware configuration respectively hard-
ware configuration from memory card.
Reset to factory setting is executed.
Reset to factory setting was finished without error. Then power
OFF/ON is mandatory.
The alternate blinking indicates that there is new firmware on the
memory card.
The alternate blinking indicates that a firmware update is exe-
cuted.
Firmware update was finished without error.
Error during firmware update.
10Hz
Hardware description
Structure > LEDs
Ä Chap. 4.20 'Diagnostic entries'
51