Content Of The Partial Acceptance Test - Siemens SINAMICS S120 Function Manual

D) Conclusion of the report
Report of the commissioning status tested and countersignatures
1. Inspection of SI parameters
2. Logging of checksums (for each drive)
3. Issuing of the Safety password and documenting this process (do not specify the Safety
4. RAM to ROM backup, upload of project data to STARTER, and backup of the project
5. Countersignature
9.10.1.2

Content of the partial acceptance test

A) Documentation
Documentation of the machine and of safety functions
1. Extending/changing the hardware data
2. Extending/changing the software data (specify version)
3. Extending/changing the configuration diagram
4. Extending/changing the function table:
5. Extending/changing the SI functions per drive
6. Extending/changing the specifications of the safety equipment
B) Functional testing of safety functions
Detailed function test and evaluation of SI functions used. For some functions this contains
trace recordings of individual parameters. The procedure is described in detail in section
Acceptance tests (Page 611).
The function test can be left out if no parameters of the individual safety functions have been
changed. In the case that only parameters of individual functions have been changed, only
these functions need to be tested anew.
When testing the functions STO, SS1 and SBC, you do not have to make any trace
recording.
C) Functional testing of the forced dormant error detection
Testing the forced dormant error detection of the safety functions on each drive (for each
control type).
● Test of the forced dormant error detection of the safety function on the drive
Drive functions
Function Manual, (FH1), 01/2013, 6SL3097-4AB00-0BP3
password in the report!)
– Active monitoring functions depending on the operating mode and the protective door
– Other sensors with protective functions
– The table is part or is the result of the configuring work
– If you are using Basic Functions, you need to activate and then deactivate STO once
again.
– If you are using Extended Functions, you need to carry out a test stop.
Safety Integrated basic functions
9.10 Acceptance test and certificate
605