Siemens SINAMICS S120 Function Manual page 423

Overview of important parameters (see SINAMICS S120/S150 List Manual)
• r0108.14
• r0899
Standstill monitoring
• r0060
• r0063
• r0063[0...2]
• p1224[0...3]
• p1225
• p1226[0...n]
• p1227
• p1228
• p1276
Open and close the brake
• p0855
• p0858
• p1216
• p1217
• p1218[0...1]
• p1219[0...3 ]
• p1220
• p1221
• p1277
Free blocks
• p1279[0...3]
Brake monitoring functions
• p1222
• p1223
Configuration, control/status words
• p1215
• r1229.1...11
• p1275
• p1276
• p1278
Drive functions
Function Manual, (FH1), 01/2013, 6SL3097-4AB00-0BP3
Extended brake control
CO/BO: Status word, sequence control
CO: Speed setpoint before the setpoint filter
CO: Actual speed smoothed (servo)
CO: Actual speed value (vector)
BI: Close motor holding brake at standstill
CI: Standstill detection threshold value
Standstill monitoring speed threshold
Standstill detection monitoring time
Standstill detection delay time
Motor holding brake standstill detection bypass
BI: Unconditionally open holding brake
BI: Unconditionally close holding brake
Motor holding brake opening time
Motor holding brake closing time
BI: Open motor holding brake
BI: Immediately close motor holding brake
CI: Open motor holding brake, signal source, threshold
Open motor holding brake, threshold
Motor holding brake, delay, braking threshold exceeded
BI: Motor holding brake, OR/AND logic operation
BI: Motor holding brake, feedback signal, brake closed
BI: Motor holding brake, feedback signal, brake open
Motor holding brake configuration
CO/BO: Motor holding brake status word
Motor holding brake control word
Motor holding brake standstill detection bypass
Brake control diagnostics evaluation
Function modules
7.3 Extended Brake Control
421