Xerox WorkCentre 7132 Service Documentation page 96

005-142 CVT Exit 1 Sensor Off Jam (Side 2)
BSD-ON:5.4
Exit 1 Sensor does not turn Off in specified time from Exit 2 Sensor Off in Reverse Output
operation.
Procedure
If the problem occurs frequently, check the following:
1. There is any area in document path that interferes with document feed.
2. Any foreign substance is attached to Roll surface.
3. Roll surface has worn abnormally.
4. Invert Gate operation is normal.
5. Regi Motor rotates normally.
6. Exit Roll performs normal Nip operation (Nip Release Solenoid operation included.)
7. Check the connectors and wires for damage.
If all above are OK, replace Exit 1 Sensor (PL 16.7). If the problem continues, replace the Exit
2 Sensor (PL 16.7). If the problem persists, replace the DADF PWB (PL 16.3).
Revision
WorkCentre 7132
005-143 CVT Exit 2 Sensor Off Jam
BSD-ON:5.4
Exit 2 Sensor does not turn Off in specified time from Exit 2 Sensor On
Procedure
If the problem occurs frequently, check the following:
1. Check if there is anything at Exit that prevents the document output.
2. Check if there is any area in the path, from Exit Rolls and output area, that interferes with
document feed.
3. Exit Motor rotates normally. If something is wrong with rotation such as step-out, check to
see if some foreign substance in Exit Motor or any other thing prevents its rotation.
January 2007
2-73
Status-indicator-raps
005-142, 005-143