Xerox WorkCentre 7132 Service Documentation page 109

Service manual
Hide thumbs Also See for WorkCentre 7132:
Table of Contents

Advertisement

A
B
Measure the voltage between the DADF PWB P759-6 (+) and GND (-) (BSD 5.1 Flag 4).
The voltage is approx. +5VDC.
Y
N
Replace the DADF PWB (PL 16.3).
Measure the voltage between the DADF PWB P759-5 (+) and GND (-) (BSD 5.1 Flag 3).
Actuate the DADF Tray Size 2 Sensor with paper. The voltage changes.
Y
N
Replace the DADF Tray Size 2 Sensor (PL 16.10).
Replace the DADF PWB (PL 16.3).
Replace the DADF PWB (PL 16.3).
Status-indicator-raps
005-197, 005-198
005-198 Document Length RAP
BSD-ON:5.4
The system detected a document with a length shorter than 115mm in the Slow Scan Direction.
Initial Actions
Power Off than On
Procedure
Check the document size. The size of the document is within the specification.
Y
N
Use a paper size within the specification.
Execute Component Control [005-205]. Actuate the DADF Feed Out Sensor with paper. The
display changes.
Y
N
Check the connections of P/J769 and P/J758. P/J769 and P/J758 are connected cor-
rectly.
Y
N
Connect P/J769 and P/J758.
Check the wire between J769 and J758 for an open circuit or a short circuit (BSD 5.4 Flag
13/Flag 14). The wire between J769 and J758 is conducting without an open circuit
or a short circuit.
Y
N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P758-3 (+) and GND (-) (BSD 5.4 Flag
14). The voltage is approx. +5VDC.
Y
N
Replace the DADF PWB (PL 16.3).
Measure the voltage between the DADF PWB P758-2 (+) and GND (-) (BSD 5.4 Flag 13).
Actuate the DADF Feed Out Sensor with paper. The voltage changes.
Y
N
Replace the DADF Feed Out Sensor (PL 16.9).
Replace the DADF PWB (PL 16.3).
Execute Component Control [005-206]. Actuate the DADF Pre Registration Sensor with paper.
The display changes.
Y
N
Check the connections of P/J781 and P/J761. P/J781 and P/J761 are connected cor-
rectly.
Y
N
Connect P/J781 and P/J761.
Check the wire between J781 and J761 for an open circuit or a short circuit (BSD 5.4 Flag
3/Flag 4). The wire between J781 and J761 is conducting without an open circuit or
a short circuit.
A
January 2007
2-86
Revision
WorkCentre 7132

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents