Xerox WorkCentre 7132 Service Documentation page 87

005-129 CVT Simplex Exit 1 Sensor Off Jam
BSD-ON:5.4
Exit 1 Sensor does not turn Off in specified time from Out Sensor Off in Simplex Mode.
Procedure
If the problem occurs frequently, check the following:
1. There is any area in document path that interferes with document feed.
2. Any foreign substance is attached to Roll surface.
3. Roll surface has worn abnormally.
4. Simp/Dup Gate is in normal position (Simp/Dup Gate Solenoid operation included.)
5. Platen Motor rotates normally.
6. Exit Motor rotates normally.
7. Check the connectors and wires for damage.
If all above are OK, replace Exit 1 Sensor (PL 16.7). If the problem continues, replace the Out
Sensor (PL 16.7). If the problem persists, replace the DADF PWB (PL 16.3).
Status-indicator-raps
005-129, 005-130
005-130 CVT Invert Sensor On Jam
BSD-ON:5.4
Invert Sensor does not turn On in specified time from Out Sensor On in Duplex Mode
Procedure
If the problem occurs frequently, check the following:
1. There is any area in document path that interferes with document feed.
2. Any foreign substance is attached to Roll surface.
3. Roll surface has worn abnormally.
4. Simp/Dup Gate is in normal position (Simp/Dup Gate Solenoid operation included.)
5. Platen Motor rotates normally.
6. Check the connectors and wires for damage.
If all above are OK, replace Invert Sensor (PL 16.7). If the problem continues, replace the Out
Sensor (PL 16.7). If the problem persists, replace the DADF PWB (PL 16.3).
January 2007
2-64
Revision
WorkCentre 7132