Xerox WorkCentre 7132 Service Documentation page 134

A B
Check the wire between J787 and J786 for an open circuit or a short circuit (BSD 5.2 Flag
5). The wire between J787 and J786 is conducting without an open circuit or a short
circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the DADF PWB P786-1 (+) and GND (-) (BSD 5.2 Flag 5).
The voltage is approx. +24VDC.
Y N
Replace the DADF PWB (PL 16.3).
Replace the DADF Nudger Motor (PL 16.6) If the problem persists, replace the DADF
PWB (PL 16.3).
Replace the DADF PWB (PL 16.3).
Revision
WorkCentre 7132
January 2007
2-111
Status-indicator-raps
005-943