Xerox WorkCentre 7132 Service Documentation page 184

A B
Check the wire between J8801 and J8846 for an open circuit or a short circuit (BSD 12.7
Flag 5). The wire between J8801 and J8846 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the resistance of the Eject Motor between J8801-2/5 (COM) and each point of
J8801-1/3/4/6 (BSD 12.7 Flag 5). The resistance is approx. 2Ohm.
Y N
Replace the Eject Motor (PL 17.7).
Measure the voltage between the Finisher PWB P8846-6 (+) and GND (-), and between
P8846-12 (+) and GND (-) (BSD 12.7 Flag 5). The voltage is approx. +24VDC.
Y N
Replace the Finisher PWB (PL 17.12).
Replace the Eject Motor (PL 17.7). If the problem persists, replace the Finisher PWB (PL
17.12).
Execute Component Control [012-086 Set Clamp Clutch ON]. The Set Clamp Clutch starts
operating.
Y N
Check the connections of P/J8822 and P/J8848. P/J8822 and
nected correctly.
Y N
Connect P/J8822 and P/J8848.
Check the wire between J8822 and J8848 for an open circuit or a short circuit (BSD 12.7
Flag 6). The wire between J8822 and J8848 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8848-A10 (+) and GND (-). The
age is approx. +24VDC.
Y N
Replace the Set Clamp Clutch (PL 17.5). If the problem persists, replace the Finisher
PWB (PL 17.12).
Replace the Eject Motor (PL 17.7). If the problem persists, replace the Finisher PWB (PL
17.12).
Replace the Finisher PWB (PL 17.12).
Revision
WorkCentre 7132
012-350 Finisher Communications Failure RAP
There is a communications error in the Finisher PWB.
Procedure
Switch off the power. Disconnect and reconnect the P/Js on the Finisher PWB. Switch on the
power.
If the problem persists, replace the Finisher PWB (PL 17.12).
P/J8848 are con-
volt-
January 2007
2-161
Status-indicator-raps
012-319, 012-350