Xerox WorkCentre 7132 Service Documentation page 113

005-280 DADF EEPROM RAP
BSD-ON:3.5
The DADF-EEPROM failed during the Read/Write operation.
Initial Actions
• Power Off than On
Procedure
Check the connection of each DADF PWB connector. The connectors are securely con-
nected.
Y N
Connect the connectors.
Turn on the power again. [005-280] reoccurs.
Y N
End
Replace the DADF PWB (PL 16.3).
Status-indicator-raps
005-280, 005-281
005-281 DADF Tray Lift Down Failure
Bottom Sensor does not turn ON in specified time from start of DADF Tray Down.
Procedure
To check Bottom Sensor output/Tray Motor operation/Tray Drive system (Torque Limiter)/Sen-
sor Actuator. Check the connections between the sensor and the DADF PWB. If OK, replace
the Bottom Sensor. If the problem persists, replace the DADF PWB (PL 16.3).
January 2007
2-90
Revision
WorkCentre 7132