Xerox WorkCentre 7132 Service Documentation page 187

012-902 H-Transport Exit Sensor RAP
BSD-ON:12.2
Paper remains on the H-Transport Exit Sensor.
Initial Actions
• Remove foreign substances on the sensor.
• Power Off/On
Procedure
Execute Component Control[012-191 H-Transport Exit Sensor]. Actuate the H-Transport Exit
Sensor (PL 16.3with paper. The display changes.
Y N
Check the connections of P/J8381 and P/J8390. P/J8381 and
nected correctly.
Y N
Connect P/J8381 and P/J8390.
Check the wire between J8381 and J8390 for an open circuit or a short circuit (BSD 12.2
Flag 3/Flag 4). The wire between J8381 and J8390 is conducting without an open
circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8390-6 (+) and GND (-) (BSD 12.2 Flag
4). The voltage is approx. +5VDC.
Y N
Replace the Finisher PWB (PL 17.12).
Measure the voltage between the Finisher PWB P8390-14 (+) and GND (-) (BSD 12.2
Flag 3).
Actuate the H-Transport Exit Sensor with paper. The voltage changes.
Y N
Replace the H-Transport Exit Sensor (PL 17.3).
Replace the Finisher PWB (PL 17.12).
Replace the Finisher PWB (PL 17.12).
Status-indicator-raps
012-902, 012-903
012-903 Paper Remains at Compiler Entrance Sensor RAP
BSD-ON:12.3
Paper remains on the Compiler Entrance Sensor.
Initial Actions
• Remove foreign substances on the sensor.
• Power Off/On
Procedure
Execute Component Control [012-150 Compile Entrance Sensor]. Actuate the Compiler
Entrance Sensor with paper. The display changes.
Y N
P/J8390 are con- Check the connections of P/J8814, P/J8825 and P/J8850. P/J8814, P/J8825 and P/
J8850 are connected correctly.
Y N
Connect P/J8814, P/J8825 and P/J8850.
Check the wire between J8814 and J8850 for an open circuit or a short circuit (BSD 12.3
Flag 1/Flag 2). The wire between J8814 and J8850 is conducting without an open
circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8850-B9 (+) and GND (-) (BSD 12.3
Flag 2). The voltage is approx. +5VDC.
Y N
Replace the Finisher PWB (PL 17.12).
Measure the voltage between the Finisher PWB P8850-B8 (+) and GND (-) (BSD 12.3
Flag 1).Actuate the Compiler Entrance Sensor with paper. The voltage changes.
Y N
Replace the Compiler Entrance Sensor (PL 17.11).
Replace the Finisher PWB (PL 17.12).
Replace the Finisher PWB (PL 17.12).
January 2007
2-164
Revision
WorkCentre 7132