Xerox WorkCentre 7132 Service Documentation page 156

012-161 Finisher Set Eject Jam RAP
BSD-ON:12.4/12.7
After the Eject Motor turned On, the Compile Paper Sensor (PL 16.9did not turn Off within the
specified time.
Initial Actions
• Power Off/On
Procedure
Execute Component Control [012-151 Compile Paper Sensor]. Actuate the Compile Paper
Sensor with paper. The display changes.
Y N
Check the connections of P/J8806 and P/J8848. P/J8806 and
nected correctly.
Y N
Connect P/J8806 and P/J8848.
Check the wire between J8806 and J8848 for an open circuit or a short circuit (BSD 12.4
Flag 3/Flag 4). The wire between J8806 and J8848 is conducting without an open
circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the Finisher PWB P8848-A6 (+) and GND (-) (BSD 12.4
Flag 4). The voltage is approx. +5VDC.
Y N
Replace the Finisher PWB (PL 17.12).
Measure the voltage between the Finisher PWB P8848-A5 (+) and GND (-) (BSD 12.4
Flag 3).Actuate the Compile Paper Sensor with paper. The voltage changes.
Y N
Replace the Compile Paper Sensor (PL 17.9).
Replace the Finisher PWB (PL 17.12).
Alternately execute Component Control [012-081 Eject Motor FORWARD ON] and Component
Control [012-082 Eject Motor REVERSE ON]. The Eject Motor starts up.
Y N
Check the connections of P/J8801 and P/J8846. P/J8801 and
nected correctly.
Y N
Connect P/J8801 and P/J8846.
Check the wire between J8801 and J8846 for an open circuit or a short circuit (BSD 12.7
Flag 5). The wire between J8801 and J8846 is conducting without an open circuit or
a short circuit.
Y N
Repair the open circuit or short circuit.
A B
Revision
WorkCentre 7132
A B
Measure the resistance of the Eject Motor between J8801-2/5 (COM) and each point of
J8801-1/3/4/6 (BSD 12.7 Flag 5). The resistance is approx. 2Ohm.
Y N
Replace the Eject Motor (PL 17.7).
Measure the voltage between the Finisher PWB P8846-6 (+) and GND (-), and between
P8846-12 (+) and GND (-) (BSD 12.7 Flag 5). The voltage is approx. +24VDC.
Y N
Replace the Finisher PWB (PL 17.12).
Replace the Eject Motor (PL 17.7). If the problem persists, replace the Finisher PWB (PL
17.12).
Replace the Finisher PWB (PL 17.12).
P/J8848 are con-
P/J8846 are con-
January 2007
2-133
Status-indicator-raps
012-161