Making Output Signal Connections; Input And Output Cross-Connection Signals For Connectors - Symmetricom TSG-3800 Series User Manual

Mount the panel in the equipment rack by performing the following steps.
1. Position the panel against the equipment rack directly above the associated tie
bar. The cable tie bar and panel requires three rack units (3RU). One rack unit
equals 1.75 inches (4.45 cm).
2. Attach the panel to the equipment rack with four screws and associated
hardware. Ensure that the screws mate with the equipment rack into which you
install the panel.
After installing the panel, secure and protect the cables on the panel. Follow the
instructions below, and use the cable support bar, item number 00112914-000-1,
and the appropriate screws.

Making Output Signal Connections

The telecommunication output signal connectors located on the panel, item number
010-076, are arranged in ten groups of pins that cross-connect with as many as five
connectors, item number 551026-0032. Each group of pins is divided into two pairs
of tip and ring wire connections.
Table 2-12. Input and Output Cross-Connection Signals for Connectors
Groups 2, 4, 6, 8, and 10
Tip Pin
T1 26 R1
T2 27 R2
T3 28 R3
T4 29 R4
T5 30 R5
T6 31 R6
T7 32 R7
T8 33 R8
T9 34 R9
T10 35 R10
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Ring Pin Tip
1 T1
2 T2
3 T3
4 T4
5 T5
6 T6
7 T7
8 T8
9 T9
10 T10
Input/Output Adapter Panels
Groups 1, 3, 5, 7, and 9
Pin Ring
36 R1 11
37 R2 12
38 R3 13
39 R4 14
40 R5 15
41 R6 16
42 R7 17
43 R8 18
44 R9 19
45 R10 20
TSG-3800 User's Guide
Installing the TSG-3800
Pin
75