Checking The Instrument Configuration - Symmetricom TSG-3800 Series User Manual

CPU
Power A: On
Type
Clk A Stratum 2
Rubidium
Clk B Stratum 2 DDS
Type
FG A T1/E1 (SSM)
FG B T1/E1 (SSM)
Alarms Minor
->

Checking the Instrument Configuration

You can display a listing of all instrument settings stored in memory (fault limits,
baud rates, and so forth) using the Setup command. Where the operator has not set
a limit, the default value is shown. The operator can also reset the limits to factory
default values or user defined default values.
To access the configuration data, type:
SETUP [start input] [ending input]
A typical display is:
->SETUP INP1.1
Input: Mode - Best AutoSwitch - On AutoReturn - On
Clock: AutoReturn - On
Inp1.1
Freq(100):
Freq(1000):
Freq(10000):
AIS
Set: 10
Clr: 2
Mode: Fail
Provisioned SSM: STU SSM Mode: Auto SSM Alarm Mode: Report E1 SSM
Bit#: 4
Priority: 1
->
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Power B: On
Mode/Status
Locked/Ref
Locked/OK
Mode/Status
Ref/Auto
OK/Auto
Limit 1 Limit 2
8000-Fail 4000-Alarm
800-Fail 400-Alarm
80-Fail 40-Alarm
BPV CRC
Set: 10 Set: 10
Clr: 2 Clr: 2
Mode: Alarm Mode: Fail
Stability Tau %Range
1.68E-15 2500.0 49%
0
1.06E-13 1500.0 49%
0
Output SSM
ST Unknown
ST Unknown
then press Enter
Limit 1
MTIE(100): 432-Fail
MTIE(1000): 864-Fail
MTIE(10000: 1728-Fail
LOS OOF
Set: 10 Set: 10
Clr: 2 Clr: 2
Mode: Fail Mode: Alarm
TSG-3800 User's Guide 107
Operating the TSG-3800
System Commands
Bypass
No
No
Limit 2
324-Alarm
648-Alarm
1296-Alarm