Modules; Output Wire Wrap Panel - Symmetricom TSG-3800 Series User Manual

Subtending Operating Mode

Modules

Table 8-1. Default Signal and Alarm Modes (Continued)
Fault
MTIE L1
MTIE L2
FREQ L1
FREQ L2
The TL1 interface is designed to be compliant with Southwestern Bell Corporation's
(SBC) Network Management Architecture (NMA). This allows for SBC's NMA to
remotely monitor and provision the 3800 Subtending TSG.
Modules
The following is a list of the only modules supported by the 3800 Subtending
software (item 14378500-000-5 Rev A.02) that can be provisioned for a valid
configuration.
CPU w/Ethernet
1-Port DS1 Input
Composite Clock Input
T1/E1 Frame Generator W/Bypass
Stratum 3E Clock
Composite Clock Output
AMI Output (20 outputs)
ESF to D4 Output
All main shelves contain a set of required modules and a combination of Output
modules depending upon the type

Output Wire Wrap Panel

The 3800 Subtending TSG requires a 23-inch high-density wire-wrap output panel
that adapts the 50-pin output connectors on the 3800 Main and Expansion shelves
to individual wire-wrap pins.
298 TSG-3800 User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CC Input
Ignore Ignore
Ignore Ignore
Ignore Ignore
Ignore Ignore
DS1 Input
23478301-001-0
(With above software installed)
23478303-002-0
23476674-000-0
23478486-001-0
23478272-001-0
23477337-000-0
23478309-000-0
23478399-000-0
12778474-002-2 Revision F – March 2004