Adding The Administrator-Level User - Symmetricom TSG-3800 Series User Manual

Table B-2. User Access (Security) Levels (Continued)
Level ID
Supervisor 3
Administrator 4

Adding the Administrator-Level User

An Administrator-level user must be added to the system when you log in for the
first time. An Administrator-level user performs initial setup and can assign user
privileges and access codes as needed; the Administrator-level user can also
configure all system parameters. If you do not create an Administrator-level user,
the TSG-3800 accepts commands from anyone with access to the COMM port.
Caution: To avoid a service call, you must add an Administrator-level
user and password before adding any other users. If you add a user
that is not at the Administrator level before adding an
Administrator-level user, you must contact Symmetricom for a
password that will allow you to log into the unit at that level again.
Perform the following steps to add an Administrator-level user for a first-time
installation.
1. Connect to the TSG-3800 using the procedure in
on page 308. The system prompt appears.
2. Type
user add
3. Enter a username and press Enter. The name you enter is the log-in name for an
Administrator-level user. The TSG-3800 prompts you for a password.
4. Enter a password and press Enter. The characters are echoed as '*'. The
password you enter will be the log-in password for the Administrator-level user.
The TSG-3800 prompts you for an access level.
5. Type and press Enter. This selects the Administrator access level. The system
4
prompt appears.
6. Type and press Enter to log off the system.
bye
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Supervisor-level users can:
Perform level 1 and 2 functions
Read or set all functions
Administrator-level users can:
Perform level 1 through 3 functions
View and set software configurations
Add, delete, or modify the user table
Log off any user from any port
and press Enter. The TSG-3800 prompts you for a user name.
System Administrator's Reference
Overview of the TSG-3800 Security System
Description
Establishing Communications,
TSG-3800 User's Guide 311