Event Listing - Symmetricom TSG-3800 Series User Manual

ALARM(CPU alarm operation)
OPER, MSG (operator setting/ message)
Abbreviations:
SSMSync Status Message (E1) or Bit-Oriented Message (T1)
SQLSync Quality Level
Table B-5. Event Listing
Event
Type
No.
1 Equipment,
Minor, Intifcfail
2 Equipment,
Event,
Restored
3 Message,
Event, Added
4 Message,
Minor,
Removed
5 Message,
Event, Oper
6 Message,
Event, Oper
7 Message,
Event, Oper
8 Input, Minor,
SQL
9 Equipment,
Event, Msg
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Local 1 PPS Occurs when the 1 PPS signal from the CPU's
Failed internal clock is too far off frequency to lock to. This
normally indicates that the CPU module needs
servicing.
Local 1 PPS Occurs when the 1 PPS signal from the CPU's
Restored internal clock has stabilized when it had previously
failed.
Module Occurs when a new module is added to the system. It
Added gives the slot and the module type.
Module Occurs when an module is removed from the system.
Removed It will also occur if power is lost on the module.
User Set Signals that the operator has set the provisioned input
Priority priority for the given port.
User Set SSM Signals that the operator has set the provisioned input
Alarm Mode priority alarm mode for the given port.
User Set This event signals that the operator has set the SSM
Input SSM selection mode for the output SSM.
Selection
Mode
Clock SQL is This event signals that the Clock module SQL is
Better Than better than the SQL of the input reference. This event
Input will not occur in Ensemble Mode.
Reference
SQL
Non-Volatile This event occurs during bootup and signals that the
Clock time stored in the battery-backed clock is not
Initialized operating.
System Administrator's Reference
System Messages
Comment
TSG-3800 User's Guide 359