Operational Check; List Of Modules And Accessories - Symmetricom TSG-3800 Series User Manual

Output Modules
Timing Insertion Module
Making Signal Connections
The output signals are available at the 50-pin connectors located on the rear panel
of the shelf. Outputs one through 20 are used by this module. Refer to
Output Signal
input/output signal connections as shown in
Table 7-57. List of Modules and Accessories
Pin
1 EAST Tip In
2 EAST Tip Out (re-timed)
3 WEST Tip In
4 WEST Tip Out
5 Slip relay (normally open)
26 EAST Ring In
27 EAST Ring Out (re-timed)
28 WEST Ring In
29 WEST Ring Out
30 Slip relay (normally open)

Operational Check

With power applied to the shelf, install the Timing Insertion module in the
appropriate slot and verify that the POWER indicator is lit. This indicates that the
module is receiving power and the module power supply is working.
Verify that the module is receiving the proper DS1 input signals by observing the
indicators. For normal operation the Power indicators should be lit; all others should
be off.
Note: The module indicators may take a few seconds after
installation to reach proper operating status.
286 TSG-3800 User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Connections, on page 56, for more information. Make DS1
Description
Table 7-57.
12778474-002-2 Revision F – March 2004
Making