Rack Mounting The Tsg-3800; Installing The Shelf - Symmetricom TSG-3800 Series User Manual

Installing the TSG-3800

Rack Mounting the TSG-3800

Rack Mounting the TSG-3800
The dimensions for each model are outlined in
space between shelves is recommended but not required when installing more than
one TSG-3800 shelf.
Table 2-1. Shelf Dimensions
Main Shelf
3800/3800E 19-inch
3800 23-inch

Installing the Shelf

The shelves mount flush to the rack or at distances of two inches (5 cm) or five
inches (12.7 cm) from the front of the rack. Mount the unit by performing the
following steps.
1. Attach a mounting bracket, item number 00476807-xxx-1, to each side of the
TSG-3800 Main Shelf, by aligning two columns (three holes per column) of the
bracket with the holes on the side of the shelf. Use six 4-40 x 3/8" screws to
attach the mounting bracket, as shown in
are attached at equal distances from the front of the unit.
2. Mount the instrument to the front of the rack rails with eight screws and washers,
as shown in
3. If you are not installing an expansion shelf, install the Bus Termination assembly
in the appropriate connector, as listed in
Table 2-2. Expansion Shelf Connections
Model
3800/3800E 19-inch
Shelf
3800 23-inch Shelf
50 TSG-3800 User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Height
10.5 in (26.7 cm)
10.5 in (26.7 cm)
Figure 2-1. Use the correct mating screws for the installation rack.
Expansion Connector
J9
J11
Table 2-1. A one RU (1.75 inch)
Depth
12 in (30.5 cm) 19 in (48.26 cm)
12 in (30.5 cm) 23 in (58.42 cm)
Figure 2-1. Ensure that both brackets
Table 2-2.
12778474-002-2 Revision F – March 2004
Width