Making Output Signal Connections; Installing Modules; Input/Output Adapter Panels; Distribution Signal Maximum Cable Length - Symmetricom TSG-3800 Series User Manual

Making Output Signal Connections

The output signals are available at the 50-contact connectors, J2 through J10, on a
19-inch rear panel and J2 through J12 on a 23-inch rear panel. Tip and ring contact
pairs are on opposite contacts (Ring = 1-20 and Tip = 26-45). Contacts 21 through
25 and 46 through 50 are shield grounds. Refer to
additional connection details for the specific Output modules being used.

Installing Modules

The first three slots in the TSG-3800X, starting from the left, must be covered with
blank filler panels (item number 10977120-000-0). Insert Output modules starting
with the fourth slot, in matched pairs. Therefore, slots 4 and 5 must contain identical
Output modules, slots 6 and 7 must contain identical Output modules, slots 8 and 9
must contain identical Output modules, and so forth. To properly install these
modules, refer to

Input/Output Adapter Panels

A variety of connector panels are available to adapt the 50-pin input/output (I/O)
connectors on the TSG-3800 series shelves to individual wire-wrap or balun
connectors for attaching to the customer's system.
Note: Distribution panels can be located at various distances from the
shelf depending on the type of output signal being used. See
2-11
installing distribution panels.
Table 2-11. Distribution Signal Maximum Cable Length
Output Signal
T1
E1
CC
RS-422
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Installing Modules, on page 63.
for signal type and the maximum cable length you can use when
Maximum Cable Length
655 feet
655 feet
1500 feet
150 feet
Installing the TSG-3800
Input/Output Adapter Panels
Chapter 7, Output Modules, for
Table
TSG-3800 User's Guide 73