Configuring The Composite Clock Output Module; Switch Settings For Phase Adjustment - Symmetricom TSG-3800 Series User Manual

Table 7-24. Composite Clock Output Module Specifications (Continued)
Signal Characteristic
Monitor
Number of Outputs

Configuring the Composite Clock Output Module

This section describes how to configure the Composite Clock Output module to
meet the requirements of your particular installation.
Caution: To prevent ESD damage to the module, always observe
the precautions described in
page 61.
Setting the Phase Adjustment
The relative phase of the output signals may be adjusted in groups of ten outputs
(1–10 and 11–20, as shown in
delay as shown in
Table 7-25. Switch Settings for Phase Adjustment
Delay Time
0 ns
700 ns
1400 ns
2000 ns
Note: When redundant modules are installed in a shelf, you must set
both modules to the same phase adjust settings.
12778474-002-2 Revision F – March 2004
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
860 Ω, Bantam jack
20
Properly Handling the
Figure 7-10). Set the front panel switches for phase
Table 7-25.
Delay Length Switch Settings
>1965 ft. On, On
(599 m)
1310 – 1965 ft. Off, On
(399 – 599 m)
655 – 1310 ft. On, Off
(200 – 399 m)
0 – 655 ft. Off, Off
(0 – 200 m)
Composite Clock Output Module
Specification
Modules, on
TSG-3800 User's Guide 239
Output Modules