Provisioning Input Reference Signals - Symmetricom TSG-3800 Series User Manual

System Administrator's Reference

Provisioning Input Reference Signals

The following commands are available:
Alarm
Configuration
Event
Id
MTIE
Ping
Status
Who
TSG->
To access command-specific help, type:
HELP «command»
where «command» is any of the commands in the list above.
Provisioning Input Reference Signals
The operator has the following controls over the input reference signals:
Selection of the input reference in use
Enabling or inhibiting automatic switching of references
Enabling or inhibiting automatic return to a higher-priority input
Selecting Input Reference Selection Mode
Assigning fault modes for violation of operating limits
Setting the number of faulted time intervals necessary to cause an alarm
Setting the number of time intervals, without incident, necessary to clear an
alarm
Setting two limits for MTIE
Setting two limits for frequency offset
On T1 or E1 X-Port modules:
Set termination
Set framing type
Set zero suppression
Set CRC
Set SSM mode
326 TSG-3800 User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Bye Clk
Date Disable
Fg Frequency
Input IP
Name Network
Reference Restart
TDEV Time
then press Enter
Comm
Enable
Help
Msg
Phase
Setup
User
12778474-002-2 Revision F – March 2004