Deleting A User; Setting Communication Parameters; Provisioning Eia-232 Parameters - Symmetricom TSG-3800 Series User Manual

System Administrator's Reference

Setting Communication Parameters

3. Type
USER MODIFY
4. Type in the
User «username» Exists; Modifying Data; ESC Aborts
Password:*****
5. Type in the new password for the user and press Enter, or press Enter to leave
the password unchanged. The terminal responds with
Access Level: «level»
6. Type in the new level for the user and press Enter, or press Enter to leave the
level unchanged. The terminal responds with
Modified User «username» User Data: Access Level is now «level».

Deleting a User

An Administrator-level user can delete usernames from the user list. The operator
must specify the username to delete. Once the username has been deleted from
the list, the TSG-3800 will not be recognize the username.
To delete a username:
1. Connect to the TSG-3800 using the procedure in
on page 308. The system prompt appears.
2. Log in as an Administrator-level user (see
3. Type
USER DELETE «username»
Setting Communication Parameters
The TSG-3800 has two EIA-232 communication ports available: COMM A is located
on the CPU module, COMM B is located on the rear panel. An optional 10BaseT
Ethernet port is also located on the rear panel. These ports allow data transfer
between the TSG-3800 and a terminal. You can configure each port independently
using the commands described in this section. Refer to
on page 59, for details on making connections to the ports.
This section describes how to set the parameters for the EIS-232 and Ethernet
ports.

Provisioning EIA-232 Parameters

Before issuing commands and collecting data, you must establish communication
between the terminal and the TSG-3800. You can customize the communication
parameters to match the requirements of your equipment. The TSG-3800 allows
you to set the following communication parameters:
314 TSG-3800 User's Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
and press Enter. The terminal requests the username.
. The terminal responds with
«username»
then press Enter.
Establishing Communications,
Logging In, on page 312).
EIA-232 Communications,
12778474-002-2 Revision F – March 2004