E1/T1 Interfaces - Avaya G450 Cli Reference Manual

Roadmap

E1/T1 interfaces

Table 31: E1/T1 port configuration CLI commands
Root level command
clear controller
counters
controller
ds-mode
interface serial
show controllers
66 Avaya G450 CLI Reference
First level command
cablelength long
(T1)
cablelength
(T1)
short
channel-group
clock source
fdl
framing
linecode (E1)
linecode (T1)
loopback
remote
ip address
Description
Reset the controller counters
Enter configuration mode for a specific controller
Set transmit and receive levels for a cable longer
than 655 feet
Set transmit levels for a cable of length 655 feet
or shorter
Create a channel group logical interface for a
PPP or Frame Relay session
Set the clock source for an E1 or T1 controller
Define the type of Facility Data Link loopback that
the remote line is requested to enter
Set the frame type for an E1 or T1 data line
Set the type of line-code transmission for the E1
line
Set the type of line-code transmission for the T1
line
Activate or deactivate loopback mode for an E1
or T1 line
Reset the far end counters on a T1 line
Set the mode of the controller to e1 or t1
Enter Serial interface or sub-interface
configuration mode
Configure the IP address and subnet mask of the
interface
Display status information about a controller
interface
1 of 2