Ethernet Port Configuration - Avaya G450 Cli Reference Manual

Table 31: E1/T1 port configuration CLI commands (continued)
Root level command
show controllers
remote
show ds-mode

Ethernet port configuration

Table 32: Ethernet port configuration CLI commands
Command
set port
auto-negotiation-flowcontrol-
advertisement
set port duplex
set port edge admin state
set port enable | disable
set port flowcontrol
set port level
set port name
set port negotiation
set port point-to-point admin
status
set port speed
show port
auto-negotiation-flowcontrol-
advertisement
First level command Description
Display controller statistics from a peer station
Display the current mode of the controller
Description
Set the flowcontrol advertisement for the specified
Gigabit Ethernet ports when performing
auto-negotiation
Configure the duplex type (full or half duplex) of an
Ethernet or FastEthernet port or range of ports
Determine whether the port is an edge port, for the
purposes of Rapid Spanning Tree Protocol (RSTP)
Enable or disable a port or a range of ports
Set the send/receive mode for flowcontrol frames
(IEEE 802.3x or proprietary) for a full duplex port
Set the default packet priority level for untagged
packets
Configure a name for a port
Enable or disable auto-negotiation on the port
Set the connection type of the port: force-true,
force-false, or auto
Set the speed of a port or range of ports
Display the flowcontrol advertisement for a Gigabit
port used to perform auto-negotiation
2 of 2
1 of 2
Issue 1 January 2008 67