Syntax
[no] caller-id alerting ring {1 | 2 }
Table 374: Variable definitions
1
2
[no]
Example
AG/configure/voice-port (7/2/1)# caller-id alerting ring 2
configure voice-port caller-id block
Use this command to request the blocking of the display of caller ID information at the far end
of a call for calls originated from on FXS port. Use this command on the originating FXS voice
port. To allow the display of caller ID information, use the no form of this command.
By default, caller ID display is not blocked.
Syntax
[no] caller-id block
Example
AG/configure/voice-port (7/2/1)# caller-id block
configure voice-port caller-id enable
Use this command to allow the sending or receiving of caller-ID information. Use this command
at the sending FXS voice port or the receiving foreign exchange office FXO voice port. By
default, the sending and receiving of caller-ID information is disabled.
Syntax
[no] caller-id enable [type <1-2>]
Command Line Reference
Variable
configure voice-port caller-id block
Value
Specifies that caller ID alerting (display) is
provided after the first ring at the receiving
station. This is the most common setting.
Specifies that caller ID alerting (display) is
provided after the second ring.
Sets the alerting ring to the default value: 1.
August 2013
345