Generator/Eddy Brake Assembly Replacement; About; Procedure - Precor Experience Series Service Manual

Generator/Eddy Brake assembly Replacement

About

This procedure provides instruction to remove and install the Generator/Eddy Brake
assembly.

Procedure

Review entire procedure before starting.
Removal Instructions
1. Remove the Drive Access cover, see
2. Remove the left and right Drive Disk covers, see
3. Remove the left and right Stairarms from the Input Crank, see
Crank Removal" on
4. Remove the Drive Top and left/right Drive Housing covers see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"" on
page 148.
6 Replacement Procedures
Generator/Eddy Brake assembly Replacement
page 73.
"" on page 74.
"Stairarm Input Drive
"" on page 78.
Page 96