Mitsubishi Electric MELSERVO-J4 Series Instruction Manual page 516

11. MR-D01 EXTENSION I/O UNIT
(b) OVR (Analog override selection)
Enable or disable OVC (Analog override).
OVR (Analog override selection)
OVC (Analog override)
-10 V to +10 V
Select a changed value by using OVR (Analog override selection).
(c) Analog override offset ([Pr. Po21])
You can set an offset voltage to the input voltage of OVC (Analog override) with [Pr. Po21]. The
setting value ranges from -9999 to +9999 [mV].
Servo amplifier
(Note) External input
signal
0 No change
Setting of OVC (Analog override) is
1
enabled.
Note. 0: Off
1: On
11 - 53
www.kavrammuhendislik.com.tr
Position Analog
control override
Speed change value
Speed Servo
control
motor