2. SIGNALS AND WIRING
Note 1. Output signals are not assigned by default. Assign the output signals with [Pr. PD47] as necessary.
2. Refer to section 9.1 for the connection of manual pulse generator.
3. This diagram shows sink I/O interface. For source I/O interface, refer to section 3.9.3 of "MR-J4-_A_(-RJ) Servo Amplifier
Instruction Manual".
4. The illustration of the 24 V DC power supply is divided between input signal and output signal for convenience. However, they
can be configured by one.
5. For the connection with external encoders, refer to table 1.1 of "MR-J4-_A_(-RJ) Servo Amplifier Instruction Manual".
2 - 42
www.kavrammuhendislik.com.tr