Mitsubishi Electric MELSERVO-J4 Series Instruction Manual page 418

8. TROUBLESHOOTING
Detail
No. Name
No.
F2.1
Drive recorder -
F2
Miswriting warning
F2.2
Oscillation
F3 F3.1
detection warning
F4.4
F4 Positioning warning F4.6
F4.7
F5.1
Simple cam
F5 function - Cam data
F5.2
miswriting warning
F5.3
F6.1
F6.2
Simple cam
F6.3
F6 function - Cam
control warning
F6.4
F6.5
F6.6
Note 1. Leave for about 30 minutes of cooling time after removing the cause of occurrence.
2. The following shows two stop methods of DB and SD.
DB: Stops with dynamic brake. (Coasts for the servo amplifier without dynamic brake.)
Coasts for MR-J4-03A6(-RJ).
SD: Forced stop deceleration
3. This is applicable when [Pr. PA04] is set to the initial value. The stop system of SD can be changed to DB using [Pr. PA04].
4. Quick stop or slow stop can be selected using [Pr. PD30].
method
Detail name
(Note 2,
Drive recorder - Area writing
time-out warning
Drive recorder - Data miswriting
warning
Oscillation detection warning
Target position setting range
error warning
Acceleration time constant
setting range error warning
Deceleration time constant
setting range error warning
Cam data - Area writing time-out
warning
Cam data - Area miswriting
warning
Cam data checksum error
Cam axis one cycle current value
restoration failed
Cam axis feed current value
restoration failed
Cam unregistered error
Cam control data setting range
error
Cam No. external error
Cam control inactive
8 - 13
www.kavrammuhendislik.com.tr
Stop
3)