Connecting The Power Cords - NEC HX4500 User Manual

Connecting the Power Cords

Plug the female end of each AC power cord into the input receptacles on the
rear of the power supplies (see Figure 2-2). Plug the male end of each power
cord into NEMA 5-15R outlet for 100-120 Vac or NEMA 6-15R outlet for 200-
240 Vac. If the power cords supplied with the system are not compatible with
the AC wall outlet in your region, obtain a suitable power cord that meets the
following criteria.
T
The power cord must be rated for the available AC voltage and have a
current rating that is at least 125% of the current rating of the system.
T
The power cord connector that plugs into the wall outlet must be
terminated in a grounding-type male plug designed for use in your region.
It must have certification marks showing certification by an agency
acceptable in your region.
T
The power cord connector that plugs into the system must be an IEC-
type CEE-22 female connector.
T
The power cord must be less than 1.8 meters (6.0 feet) long.
Your system shipped with two AC power cords. Do not
attempt to modify or use the supplied AC power cords if it
not the exact type required.
2-6 Setting Up Your System
!
WARNING
Figure 2-2. Connecting the AC Power Cord