H3C S7500E Series Command Reference Manual page 26

Flow-control is not enabled
The Maximum Frame Length is 9216
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Link delay is 0(sec)
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Port priority: 0
Peak value of input: 0 bytes/sec, at 2000-04-26 17:18:22
Peak value of output: 0 bytes/sec, at 2000-04-26 17:18:22
Last 300 seconds input: 0 packets/sec 0 bytes/sec -%
Last 300 seconds output: 0 packets/sec 0 bytes/sec -%
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
Table 1-5 display interface command output description
Field
current state
IP Packet Frame Type
Hardware address
Description
Loopback
Unknown-speed mode
unknown-duplex mode
The Maximum Frame Length
Broadcast MAX-ratio
Physical state of the Ethernet interface. For details, see
Ethernet framing format on the port.
Hardware address of the port.
Description of the port.
Loopback testing status on the port.
The port will negotiate a speed with its peer.
The port will negotiate a duplex mode with its peer.
The maximum Ethernet frame length allowed on the port.
Broadcast suppression threshold as a percentage of the port
transmission capability. When the threshold is exceeded, the port
drops broadcast packets.
1-11
Description
Table 1-6.