H3C S7500E Series Command Reference Manual page 271

undo port hybrid vlan vlan-id-list
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
vlan-id-list: VLANs that the hybrid ports will be assigned to. This argument is expressed in the format of
[ vlan-id1 [ to vlan-id2 ] ]&<1-10>, where vlan-id ranges from 1 to 4094 and &<1-10> indicates that you
can specify up to 10 VLAN IDs or VLAN ID ranges. Be sure that the specified VLANs already exist.
tagged: Configures the port(s) to send the packets of the specified VLAN(s) with the tags kept.
untagged: Configures the port to send the packets of the specified VLAN(s) with the tags removed.
Description
Use the port hybrid vlan command to assign the current hybrid port(s) to the specified VLAN(s).
Use the undo port hybrid vlan command to remove the current hybrid port(s) from the specified
VLAN(s).
By default, a hybrid port only allows packets from VLAN 1 to pass through untagged.
A hybrid port can carry multiple VLANs. If you execute the port hybrid vlan command multiple times,
the VLANs the hybrid port carries are the set of VLANs specified by vlan-id-list in each execution.
In port group view, this command applies to all ports in the port group. For more information about
port groups, see Ethernet Interface Configuration in the Layer 2 – LAN Switching Configuration
Guide.
In Layer 2 aggregate interface view, this command applies to the Layer 2 aggregate interface and
all its member ports. After you perform the configuration, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member
ports. If it fails to do that on an aggregation member port, it simply skips the port and moves to the
next port. For more information about Layer 2 aggregate interfaces, see Ethernet Link
Aggregation Configuration in the Layer 2 – LAN Switching Configuration Guide.
Related commands: port link-type.
Examples
# Assign the hybrid port GigabitEthernet 2/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100,
and configure GigabitEthernet 2/0/1 to send packets of these VLANs with tags kept.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] port link-type hybrid
[Sysname-GigabitEthernet2/0/1] port hybrid vlan 2 4 50 to 100 tagged
# Assign hybrid ports in port group 2 to VLAN 2, and configure these hybrid ports to send packets of
VLAN 2 with VLAN tags removed.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] port-group manual 2
13-15