Reset Counters Interface - H3C S7500E Series Command Reference Manual

Parameters
number: Number of the aggregate interface corresponding to an aggregation group, in the range 1 to
128.
Description
Use the port link-aggregation group command to assign the current Ethernet interface to the
specified aggregation group.
Use the undo port link-aggregation group command to remove the current Ethernet interface from
the aggregation group to which it currently belongs.
Note that:
An Ethernet interface can belong to only one aggregation group.
To achieve optimal load sharing effect, ensure that a link aggregation group contains only one
type of port, for example, only gigabit Ethernet or 10-gigabit Ethernet.
When you configure cross-card link aggregation, if link aggregation across different types of cards,
however, you may need to enable MAC address table synchronization manually,
Related commands: synchronization mac-address enable
Examples
# Assign Layer 2 Ethernet interface GigabitEthernet 2/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] port link-aggregation group 1

reset counters interface

Syntax
reset counters interface [ bridge-aggregation [ interface-number ] ]
View
User view
Default Level
2: System level
Parameters
bridge-aggregation: Clears statistics for Layer 2 aggregate interfaces.
interface-number: Aggregate interface number. If the interface-number argument is not specified, this
command clears statistics of all aggregate interfaces of the specified type.
Description
Use the reset counters interface command to clear the statistics of the specified aggregate interface
or interfaces.
Before collecting statistics for a Layer 2 aggregate interface within a specific period, you need to clear
the existing statistics of the interface.
Note that:
If none of the keywords and argument is specified, this command clears the statistics of all
interfaces in the system.
9-22